Done!

[errantember]

After taking several months to do the left side of the Puggle Fence, I managed to knock out the right side (which was about half as big) in a few days. Tomorrow I will mount it in place, which will require a bit of tricky angle cutting, as it comes into the curb at an angle. Once that's done, I'll be able to take the real (as opposed to diagrammed, theoretical) measurements for the gate, which should be much faster. I'll be using welded wire for most of the gate structure, which should make it much lighter than if I used the same design as the right and left sides.

I'll post pictures when I'm done, and the Puggle is Contained!